Table of Contents
Advertisement
SPECIFIC SAFETY RULES FOR THE CUTOUT TOOL
WARNING! This tool has sharp, fast-moving parts. Misuse can cause severe injury.
Always follow the safety instructions below.
1.
Hold tool by the insulated gripping handles when performing an operation
where the cutting tool may contact hidden wiring or its own cord. Contact with
"live" wire will make exposed metal parts of the tool "live" and shock the operator.
2.
Under no circumstance is the Cutout Tool base ever to be removed from the tool
in order to use bits that are too large to use with the base assembly attached.
Removal of the base, and using the tool "free hand" can lead to serious bodily injury.
Do not use router bits on the Cutout Tool
3.
Never touch the bit, collet, or any other moving parts while the Cutout Tool is in
operation.
4.
Never lay the Cutout Tool down until the bit has stopped rotating completely.
5.
Hold the Cutout Tool firmly when starting, as startup rotation creates significant
torque.
6.
Never hold workpiece by hand. Secure the workpiece by clamping, or with other
holding devices.
7.
Make sure the workpiece is free of nails and other obstacles. These can interfere
with the cutting process, and possibly cause damage and injury.
8.
Hold the tool firmly while cutting. The action of the bit against the workpiece can
cause it to "kick out," jumping rapidly away from the workpiece. This can be caused by
an improper type, or dull bit being used.
9.
Do not handle the Cutout Tool bit immediately after cutting. It may be very hot,
potentially causing burns or injury.
10. Avoid overloading the tool. If the speed drops abnormally, decrease the pressure on
the bit immediately. Do not apply excessive pressure to the tool while cutting.
11. Always use sharpened bits. If the bit stops abruptly, or the bit becomes blocked,
remove the tool from the workpiece and shut it off.
12. Never start the Cutout Tool while the bit is in contact with workpiece. Allow the
tool to reach its normal operating speed before applying the bit to the workpiece.
13. Maintain labels and nameplates on the Cutout Tool. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
14. Always wear ANSI approved safety impact eye goggles and heavy work gloves
when using this tool. Using personal safety devices reduce the risk for injury. Safety
impact eye goggles and heavy work gloves are available from Harbor Freight Tools.
SKU 92879
For technical questions, please call 1-800-444-3353
Page 4
Advertisement
Table of Contents
