Download Print this page

Sealey G2000I.V2 Instructions Manual page 6

Inverter generator 2000w 230v 4-stroke engine

Advertisement

7.5.
Muffler Screen and Spark Arrester
WarnIng! The engine and muffler will be very hot after the
engine has been running.
7.5.1.
Remove the screws fig.18.1, then pull off cover fig.18.2.
7.5.2.
Loosen the bolt fig.19.3 and then remove the muffler cap fig.19.4,
the muffler screen fig.19.5, and spark arrester fig.20.6.
7.5.3.
Clean the carbon deposits on the muffler screen and spark arrester
using a wire brush fig.21. When cleaning use the wire brush gently
to avoid damaging or scratching of the muffler screen and spark
arrester.
7.5.4.
Check the muffler screen and spark arrester. Replace them if damaged.
7.5.5.
Install the spark arrester. Align the spark arrester projection fig.22.7
with the hole fig.22.8 in the muffler pipe.
7.5.6.
Install the muffler screen and the muffler cap.
7.5.7.
install the cover and tighten the screws.
7.6.
fuel tank filter
WarnIng! Never use petrol while smoking or in the vicinity of an open flame.
7.6.1.
Remove the fuel tank cap and filter. fig.23
7.6.2.
Clean the filter with petrol in a wash tank.
7.6.3.
Wipe the filter and install it.
7.6.4.
install the fuel tank cap. Be sure the fuel tank cap is tightened securely.
7.7.
fuel filter
7.7.1.
Remove the screws fig.24.1 and then remove cover fig.24.2 and
drain the fuel fig.25.3.
7.7.2.
Hold and move up the clamp fig.25.4 and the take off the hose fig.25.5
from the tank
7.7.3.
Take out the fuel filter fig.26.6.
7.7.4.
Clean the filter with petrol.
7.7.5.
Dry the filter and put it back into tank.
7.7.6.
install the hose and clamp, then open the fuel valve to check
if it is leaking.
7.7.7.
install the cover and tighten the screws.
8. storage
8.1.
Drain the fuel
8.1.1.
turn the engine switch to "stoP"
8.1.2.
Remove the fuel tank cap and filter. Extract the fuel from the fuel tank into an approved fuel container. Replace fuel tank cap.
8.1.3.
start the engine and leave it to run out of fuel. Approx 20min.
8.1.4.
Remove the screws and cover fig.24.
8.1.5.
Drain the fuel from the carburettor by loosening the drain screw on the carburettor float chamber.
© Jack sealey limited
Original Language Version
fig.18
fig.20
fig.24
G2000i.V2 | issue 1 05/09/16
fig.19
fig.21
fig.22
fig.23
fig.25
fig.26

Advertisement

loading