Tekky Convulsing Werewolf Installation And Operating Instructions

CONVULSING werewolf
INSTALLATION AND OPERATING INSTRUCTIONS
KEEP ALL PLASTIC AND WIRE PARTS AWAY FROM CHILDREN
FEMALE

PARTS

1. LONG POLES (4 FEMALE & 4 MALE)
2. SHORT POLE (FEMALE / FEMALE)
3. METAL STAND
4. FEET (2)
5. PANTS WITH BRACKET
6. HEAD WITH ARMS AND CHAINS
7. MODULE
8. LOCKING PINS
1. Assemble LONG POLES, 4 MALE to 4 FEMALE (Match A to A). Twist to lock.
2. Attach LONG POLES to METAL STAND.
3. Slide FEET over assembled LONG POLES connected to METAL STAND.
4. Slide PANTS over assembled LONG POLES connected to METAL STAND.
5. Attach MODULE to assembled LONG POLES.
Note: MODULE labeled FRONT should be pointing same way as the front of the FEET.
6. Locate holes in the top of the LONG POLES. Turn the poles and line up holes in top of the LONG POLES
with the holes on MODULE. (Holes are located on MODULE front left and MODULE back
right.) Insert LOCKING PINS as illustrated. (See illustration 6 and 6a)
7. Attach PANTS BRACKET to holes on either end of MODULE, inserting metal prongs
facing down. (See illustration 7)
8. Attach SHORT POLE to HEAD WITH ARMS AND CHAINS. (Match B to B) Twist to lock.
9. Attach opposite end of SHORT POLE to MODULE. (Match B to B) Twist to lock.
10. Connect cable located under clothes to cable coming from MODULE. (Match C to C)
MALE
FRONT
1. 2. 3. 4. 5. 6.
PAGE 1
7.
8.
1
A
A
3
FRONT
FRONT
6
HOLE
7
9
B
B
FRONT MODULE
2
FRONT
4
5
6a
8
10