AADCO 737 Series Operating Instructions Manual page 7

1.9 For INSTALLATION WITH COMPRESSOR, place the compressor assembly,
Figures 1 and 2 (50), between two level surfaces so that the underside of the
assembly is exposed. DO NOT INVERT. Remove the two red shipping bolts
located on the underside and retain for future use.
1.10 Place the generator unit and compressor unit side by side as shown in Figures 1
and 2, with the compressor unit, Figures 1 and 2 (50), left of the generator unit as
shown. Place the ballast tank Figures 1 and 9 (16), on top of the compressor
unit and install the curved metal tubing which is supplied and labeled, Figure 2
(53), between the compressor outlet fitting and the check valve on the ballast
tank, Figures 1, 2 and 9 (24).
1.11 Install the ¼-inch o.d. plastic tubing, Figure 1 (51), supplied between the outlet
fitting on top of the ballast tank and the PUMP fitting, Figure 1 (58), on the rear of
the generator unit. Lastly, install the dump muffler in the DUMP fitting Figure 1
(60) and direct downward.
1.12 Connect the compressor power cord into the AUX POWER outlet on the lower
rear of the generator unit, as shown in Figure 1. Once the six-foot power cord
has been inserted into the proper electrical outlet, the unit is ready for operation.
3