Maintenance; Maintenance Program; Maintenance Record; Servicing Equipment - Toshiba HV6AS Instruction Manual

MAINTENANCE

MAINTENANCE PROGRAM

In order to ensure continued reliable and safe
operation of the equipment, a program of
periodic maintenance must be established.
Operating and environmental conditions will
usually dictate the frequency of inspection
required. NFPA Publication 70B
Equipment Maintenance" may be used as a
guide for setting up the maintenance program.
Contact with energized
DANGER
components can cause
severe injury, death and
property damage. Turn off
and lock-out primary and
control circuit power before
servicing.
Improper maintenance can
WARNING
cause severe injury, death
and property damage. Only
qualified and authorized
persons are to install,
operate or service this
equipment.
Grease is conductive. Do
WARNING
not allow grease or any
other substances to
contaminate insulating
materials. Contaminated
insulators can allow a
short-circuit or ground
fault to occur.
NOTE: Refer to the SAFETY section of this
manual for important information.

MAINTENANCE RECORD

Keep a permanent record of all maintenance
work. At a minimum, this record should include
information on:
1) Items inspected
2) Reports of any testing
3) Equipment condition
4) Corrective actions or adjustments
5) Date of work
6) Comments
The degree of detail of the record will depend
somewhat on the operating conditions.

SERVICING EQUIPMENT

For your safety, turn off and lock out main and
control circuit power before servicing the circuit
"Electrical
breaker.
must be followed:
1) Only qualified personnel should attempt
this service.
2) Never perform service on or next to
exposed components energized with line
voltage.
WARNING
Certain minimum safety procedures
Failure to adhere to these
safety procedures can
result in severe injury,
death and property
damage.
Page 25