MTS Systems OW100 Quick User Manual

Starting your device OW100
• Standby mode will be started after switch on the power switch of the device.
Operational Procedure:
1. Switch "ON" device.
2. Attach water cartridge to device.
3. Plug applicator to device.
4. Press "FILL"Button" to fill the Applicator.
5. Set up "Treatment Parameters".
6. Start treatment.
7. Stop treatment.
8. Press "DRAIN" button" to drain water from applicator.
(Lift up applicator to drain completely all water from applicator lines).
9. Press "SETUP" button to go to SETUP Screen.
10. Press "CARTRIDGE" button to eject cartridge.
11. Press "APPLICATOR" button to remove applicator from device.
12. Press "BACK" button to return to Main Screen.
13. Press "Yellow" button until device switches off.
14. Switch the power switch off to turn off completely your OW100®
Shockwave device.
Attention: The Instruction for Use OW100 Part 1 and Part 2 belongs to this document and has to be observed
(Instruction for Use)
OW100 QUICK USER GUIDE
®
• To switch ON the device, keep the yellow button press until device starts.
IFU
Switch On
Step 2
Attach Cartridge
Step 3
Plug Applicator
Dokukennung_Titel_Revision (Code_Titel_Revision)
MTS_OW100_IFU_Quick-Guide_E_A
Ausgabedatum (Date of Release)
(TT.MM.JJ)
19.04.2016
Step 1
device
Seite (Page)
1 / 4