MSA 4x4 Dropslide Install Manual

Congratulations on your purchase of a quality MSA 4x4 Dropslide. Please follow these instructions to ensure that your new
Dropslide is installed properly.
Dropslide Handle must be installed prior to slide installation.
1. Using an Allen key (supplied) ensure 6mm bolt is tight on both lever arms and remove Nylock nut and steel washer from outside of bolt (fig 1.). Leave 6mm
brass washer on bolt on the outside of the lever arms (fig 2.).
2. Place one side of handle over 6mm bolt and then, pushing lever arms together, place other side over 6mm bolt (fig 3.). ** PLEASE NOTE: you will notice that
the handle arms have a curve. Install the handle so that when the handle is lowered, the curve goes down. Install steel washer on the outside (fig 4.). Install
6mm Nylock nut (fig 5.). Holding the 6mm bolt with the Allen key on one side, tighten the Nylock nut (fig 6.).
Fig 3.
3. After both sides of handles are installed squirt lubricant between lever arms with a product such as Innox or WD-40 (fig 7.).
Fig 1.
Fig 4.
Fig 2.
Fig 5 . Fig 6.