Tech Lighting ELEMENT E4-L A Series Installation Instructions Manual

Installation Instructions for
Round or Square Element 4" Adjustable Housing
LED ROUND SQUARE -
G ENERAL RODUCT NFORMATION P I
This product is suitable for indoor locations.
This product can be dimmed with a standard electronic dimmer.
This instruction shows a typical installation.
Install the Housing with Adjustable Bars
1A
LEAVE TAB
IN PLACE
½" to ¾"
NOTE:
Skip this section if installing the housing
with butterfly brackets.
Keep Tab for ceiling ½" to ¾" thick.
1
When using adjustable hanger bars with ½" to ¾" thick
ceilings, leave the tab of the hanger bars in place.
Break off Tab for ceiling ¾" or thicker.
When using adjustable hanger bars with ¾" or thicker
ceilings, remove the tab by bending it at the perforation.
/
:
BREAK OFF
AND DISCARD
¾" or thicker
CAUTION RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1B
NAIL
OUTER ADJUSTABLE BAR
Slide the inner adjustable bar completely through the
2
three housing clasps. Make sure the nail is on top.
Slide and push the outer adjustable bar completely onto
3
the inner adjustable bar so that the tab clicks into place
behind the stop point. This will prevent the adjustable bars
from coming apart.
Repeat steps 2 & 3 for the other side of the housing.
4
1
E4_-L_A_
-
INNER ADJUSTABLE BAR
3
HOUSING CLASP
STOP POINT
3
TAB
920E4LED-A
1.2
HOUSING
2