Advertisement
6.9.
When a log becomes jammed allow the log pusher to return to the start position. Place a wedge under the jammed log and push the
wedge with the log pusher as shown below in fig.6. Repeat the process with progressively larger wedges until the log is freed.
7. maintenance
7.1.
The hydraulic oil should be replaced after every 150 hours of use with a good quality oil such as Sealey HJO5LT.
7.2.
ensure the log splitter is disconnected from the mains power supply.
7.3.
Place a container with a minimum capacity of 4 litres up against the front support leg and directly under the oil filler bolt with integral
dipstick (see fig.2-14).
7.4.
remove the oil filler bolt with dipstick and tip the log splitter forwards on the support leg so that the oil drains into the container as
shown below in fig.7-A.
7.5.
Tip the unit back on its wheels to a near vertical position and support it in this position as shown in fig.7-B. Refill the unit with 3 ½ litres
of hydraulic oil. drop the oil filler bolt with integral dipstick into the filler hole and remove again to check the oil level which should be
between the two grooves on the dipstick.
7.6.
screw the oil filler bolt back into the filler hole and fully tighten to avoid leakage.
7.7.
7.8.
7.9.
7.10.
7.11.
7.12.
7.13.
7.14.
7.15.
7.16.
7.17.
7.18.
7.19.
7.20.
7.21.
7.22.
7.23.
7.24.
7.25.
7.26.
7.27.
7.28.
7.29.
7.30.
7.31.
7.32.
7.33.
7.34.
7.35.
7.36.
7.37.
7.38.
7.39.
7.40.
7.41.
7.42.
7.43.
7.44.
© Jack sealey limited
fig.5
fig.7
Original Language Version
lS370H, LS520H | Issue 4 02/05/17
fig.6
Advertisement
