IAdea XDS-1073 Quick Start Manual

Content Management
Please consult the software documentation for information specific to your
content management solution.
Troubleshooting
How do I interrupt playback and enter setup menu?
Use USB mouse to click and hold one corner of the screen
for 10 seconds to exit playback and enter setup menu.
How do I provide a DEBUG log for a misbehaving signboard to the support team?
Please follow the instructions below to collect the player's DEBUG log:
1 Prepare a blank USB stick in FAT-32 format.
2 Create a folder named "DEBUG" (case insensitive) in the root of USB stick.
3 Make sure the player is operating (see welcome screen or playing content).
4 Insert the USB stick into player and wait for 30 seconds.
5 Within the "DEBUG" folder, is a folder with a string of number as its name.
If the string of numbers are all zero's, the debug log has not been collected
properly. Repeat step 1-4 again and make sure to wait the 30 seconds.
6 Zip the"DEBUG" folder and send to IAdea Support Team.
Reseting smart signboard to factory default
Factory reseting the smart signboard will result in the removal of all saved con-
tents, passwords, and configurations in settings. Please refer to the steps below
to complete the smart signboard factory reseting process:
1 Use a pen to press and hold the reset button - do not release until Step 4.
2 Insert the power cord.
3 Wait 30 seconds for the system reboot indicating your data is erased.
4 Release the reset button and your smart signboard will initialize in factory
default state.
IAD_DGS_X7S_40EP
XDS-1073
Quick Start Guide
This is a quick walkthrough of the set up process. For complete documentations
and quick start guides, please visit http://support.IAdea.com.
Box Content
Smart AC adapter
signboard (with selected power plug)
Mounting and Installation
Mounting option 1: VESA mount
- VESA standard: VESA MIS-D75 (75 mm x 75 mm)
- Screw: M4 x 4 mm (excluding the mounting plate thickness)
Mounting option 2: using back cover
- Power / SD card brackets MUST NOT be connected when mounting cover
- plate
Mounting option 3: glass mount
- 3M VHB™ Industrial Heavy Duty Mounting Tape (90 mm x 70 mm)
Mounting back cover
1) Release the cover 2) Install cover plate
plate screw to (thread head height
release cover plate not to exceed 3 mm)
Power and micro Table stand
SD card brackets
3) Run power and network
cable from the bottom
and connect to signboard
before mounting