FlashVAPE How To Use

How to use the FlashVAPE
The FlashVAPE is very easy to use. If you can count
to five you can use the FlashVAPE.
This brilliant vaporizer is designed for reliability and
user-friendliness.
You simply:
1. Insert the battery and turn on the main power switch.
2. Fill the Bowl (heating chamber) approximately half full.
3. Press the Start button and count to 5.
4. Release the button, and inhale the vapour!
There is no waiting, no heating, it's that simple!
When you're ready for your next inhalation, simply
shake the herbs in the FlashVAPE for uniform
distribution in the Bowl. Press the Start button again,
count to 5 and you can inhale again.
The FlashVAPE is designed for efficient evaporation; it
can be used for herbal and solid concentrates.

Temperature

The correct temperature for vaporization or evaporation
is between 190 °C and 230 °C (250 °C for solid
concentrates). These temperatures are reached 4 to 5 seconds after the Start button is
pressed. So, if you use the Start button, you have all the control over reaching the correct
temperature for evaporation. After trying and refining the length of time, you will find the
right rhythm, combined with inhaling speed and power. You have total control over
vaporizing / evaporating your herbs.

Important notes:

- Half-fill the Bowl or heating room for efficient evaporation. This also allows you space to
shake the herbs for the next evaporation.
- Every half-filled bowl, or heating room, allows you to inhale about 10 to 15 times with a
heating time of 5 seconds before the active ingredients are vaporized.
- A fully charged battery can be used about 2 to 3 times, however it is advisable that you
charge the battery after each use.
- DO NOT press the Start button and hold it longer than 5 seconds as the temperature
inside the heating chamber can reach well above 300 °C.
- DO NOT inhale when the Start button is pressed. The air flow will reduce the heat for
evaporation in the heat chamber. The hot air can hurt your throat. Always wait 1 second to
inhale after releasing the Start button.