Getting Started - Levoit Premier 100 User Manual

G E T T I N G S TA R T E D
Note:
•
Use with essential oils and water. Never use
essential oils without water.
•
Only use with natural essential oils.
Synthetic essential oils may damage
the diffuser.
1. Before first use, clean the diffuser (see
page 8) and install the splash guard.
Remove the diffuser cover and place the
splash guard into the splash guard slot.
[Figure 1.1 - 1.3].
Note: The splash guard helps prevent water
from splashing out of the diffuser when the
cover is taken off.
2. Place the diffuser on a level, elevated,
and water-resistant surface, such as a
table or nightstand.
Note: Keep mist away from walls, furniture,
and appliances to prevent them from
getting wet.
3. Attach the power adapter to the DC
socket base, then plug into an outlet.
4. Remove the cover from the base. Use the
included cup to fill the inside of the base
with cold or room temperature distilled
water (below 104°F / 40°C). Do not fill
above the "MAX" line.
5. Add 1–2 drops of essential oil per 100 mL
(approx. ½ US cup) of water, based on
your preference.
Note: If you use water-soluble essential oil
with lower concentration, the aroma will be
very light.
6. Put the cover back on the base.
6
[Figure 1.4]
Figure 1.1
Figure 1.2
Figure 1.3
Max Line
Figure 1.4