Related Manuals for MINIMO ONE Series
Summary of Contents for MINIMO ONE Series
- Page 1 Motor OPERATION MANUAL A combination of C2212 conforms to EN specification EN60745-1、 EN60745-2-3 EN61000-6-4、 EN61000-4-2、 EN61000-4-3、 EN61000-4-4 EN61000-4-5、 EN61000-4-6、 EN61000-4-8、 EN61000-4-11 Products are subject to change without notice.
- Page 2 Warning ■Make sure whether or not the handpiece runs after switching on. Thank you very much for purchasing Minimo ONE Series Ver. 2 Motor. If the handpiece does not run after switching on, stop using it. ○Failure to do so could cause the motor to be overheated, resulting in fire or failure.
-
Page 3: Specifications
KM11G KM112G Low gear 6,600 ・○ is possible combinations of Head joint Belt Speed One Series Ver.2 Type Speed Range ※This instruction manual is shared for every Minimo One Series Ver.2 motor. [m/min] [times/min] C2012 RE11 RE112 Reciproca ― 3,500 ・... -
Page 4: Operating Procedure
Curl Cord ５－２．Connecting to Powerpack Connect the curl cord properly with the powerpack. fig-１０ fig-１１ Minimo One Series Ver.2 handpieces cannot be connected with the previous version powerpack including Minimo One Series. Use equivalent carbon brushes. ■ ５－３．Operation of Hand Switch ■After replacing the carbon brushes, give the handpiece a trial run, increasing rotation... -
Page 5: Troubleshooting
７. Accessories Carbonbrush 1set （２pieces） Ｒｕｂｂｅｒ Ｃｒａｄｌｅ ＲＭ１１ Carbon Motor brush KV112H KE-605 KV212H KE-580 KM112H KE-575 KM212H KE-580 KV212 KE-580 KM112 KE-575 KM212 KE-580 KM212L KE-580 KM112G KE-575 ８. Trouble Shooting Condition Investigation Corrective action Is an AC cord unplug? Please plug an AC cord. Is a fuse blown? Please replace e equivalent fuse.
Need help?
Do you have a question about the ONE Series and is the answer not in the manual?
Questions and answers