Related Manuals for MINIMO ONE Series
Summary of Contents for MINIMO ONE Series
- Page 1 POLYTOR POWER PACK Ｐ30 OPERATION MANUAL Products are subject to change without notice.
- Page 2 Warning ■For your ear protection, wearing earplugs on work is recommended while using ultrasonic devices. Thank you very much for purchasing Minimo ONE Series POLYTOR Power Pack. ○Unexpected damage may occur caused by loud sound while working. ■Do not touch joint part of holder, holder and SENTAN TOOL while handpiece is in operation and immediately after stopping.
-
Page 3: Table Of Contents
Contents ２. Product Features ●Supporting wide input voltage Introduction ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ １ This product can be used with voltage range 100V AC - 230V AC. Safety Precautions・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ １～２ ●2 Driving modes of handpiece can be selected. ・ STROKE CONTROL ： Driving with constant voltage. Contents ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・... -
Page 4: Names And Functions Of Each Component ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ ５～６
⑦ULTRA SONIC ON/OFF Switch・ULTRA SONIC Output Light ４. Names and Functions of Each Component To use and control On/Off of a handpiece Pressing the ULTRA SONIC On/Off switch will run a handpiece and then pressing the switch again stop the handpiece. The colors of the ULTRA SONIC output light indicate the followings: Frontside Backside... -
Page 5: Operating Procedure
（表示器等のランプが点灯します ５. Operating Procedure ６. Explanation for Drive Modes of Handpiece ●STROKE CONTROL ５-１ Without Foot Switch Voltage is increased/decreased for stable amplitude amount of handpiece. （１）Always confirm that the AC power cord has been fully inserted into the socket of the power pack, and plug it in an outlet. STROKE CONTROL mode is suitable for heavy-load works such as deburring and rough finishing because it tries to keep ... -
Page 6: Trouble Ｓhooting
８. Trouble Shooting ９. Accessories ■In case that errors occur, the error information will be displayed on the front panel. AC Power Cord cord length：2m ■This information is provided first by「E.-」showing error occurrence. Then, simple displays such as「OL」(Overload) ＣＡ１０ ＣＡ１１ ＣＡ１２... -
Page 7: Before Asking For Repair
１０. Before Asking for Repair １１. Maintenance and Inspection ●Please check if there is some damage or not on the case and cord. Condition Investigation Corrective action ●Please check if there is accumulated dust, oil, water and so on. Power is not ON. ※Please make sure to perform maintenance and inspection properly.
Need help?
Do you have a question about the ONE Series and is the answer not in the manual?
Questions and answers