Advertisement
Installation instructions
1. Twist the diffuser in the anti-clockwise direction and remove it, see figure 1.
2. Route the mains cable through the cable entry hole, see figure 2.
3. Secure the base onto the ceiling or wall using the wall plugs and screws supplied or use appropriate
fixings to suit the type of building construction material, see figure 3.
4. Strip 9mm insulation length from mains cable, connect and terminate wires to the terminal block. Be
careful with multi-strand conductors that all the strands are twisted together before insertion into
the terminal. Any stray strands that inadvertently come into contact with their neighbouring terminal
will cause undesirable results when the fitting is powered. Refer table below and see figure 4.
Wire/fitting type
Switched active (SA)
Unswitched active (A)
Neutral (N)
Earth
Note: For permanent maintained operation, loop unswitched active (L
5. This step is for emergency version only; ensure the battery is connected to the emergency module.
6. Energise the fitting and check operation to ensure that the installation was successful. Refer to the
troubleshooting guide on the last page if abnormal operation or indication is encountered.
7. This step is for emergency version only; once powered up allow a few minutes to give the battery a
small charge then press the test button adjacent to the indicator LED. Check the operation and LED
indications per the following tables. Refer to the troubleshooting guide on the last page if abnormal
operation or indication is encountered.
Fitting type
AC and emergency
LEDs will illuminate to full brightness when
without motion detect
AC and emergency with
The operation of the LEDs in normal mains
motion detect sensor
availability is dependent on the settings of
the motion detect module. Please refer to
motion detect sensor - settings section for
Fitting type
Emergency
8. Reinstall the diffuser and turn it clockwise direction to lock in place, see figure 5.
Maintained - with SA
Non-maintained
Wire to terminal L
Wire to terminal L
1
Wire to terminal L
Wire to terminal N
Wire to terminal N
Wire to terminal E or
Wire to terminal E or
) to switched active (L).
1
Normal operation
Test switch pressed
(after few minutes charging)
LEDs will illuminate at approximately 10%
SA is energised
of mains brightness.
LEDs will illuminate at approximately 10%
of mains brightness.
details.
Indicator LED state - on initial powering - no fitting faults
Motion detect sensor - settings
Not connected
1
Detection pattern
Solid green
Removal instructions
1. Before removing the fitting, de-energise and
lock off the supply circuit.
2. Twist the diffuser in the anti-clockwise
direction and remove it, see figure 1.
3. This step is for emergency version only;
disconnect the battery connection from the
power pack.
Detection area
• Detection area can be reduced by selecting
the combination on the DIP switches to fit
precisely for each specific application.
Hold-time
• Hold-time means the time period you would
like to keep the lamp on 100% after the
person has left the detection area.
Daylight sensor
• The daylight threshold can be set on DIP
switches, to fit for particular application.
Stand-by period (corridor function)
• This is the time period you would like to keep
at the light output level before it is
completely switched off in the long absence
of people.
Note: "0s" means on/off control;
"+" means bi-level dimming control, fixture
never switches off.
Stand-by dimming level
• This is the dimmed low light output level you
would like to have after the hold-time in the
absence of people.
4. Remove the mains supply cables from the
terminal block.
5. Unscrew the mounting screws and remove the
housing.
Note: When the fitting is reconnected to the
supply, it will need 24 hours charging time before
it will be capable of a full duration discharge.
Advertisement
