2. The heater base and heating elements. 3. The light’s adaptor, dimmer unit and connection box. 4. Wireless dimmer switch. 5. Embedding flange for lower bench embedding. Instruction manual | Float electric heater Page 2...
DO NOT touch one another, or the outer casing. NOTE! Soapstone, rounded stones or natural stones may only be used at the surface level. 13. IKI-Kiuas recommends, for safety reasons, to build a safety railing around the heater if the heater is in public or semipublic use.
500 mm from a vent that is directing air away from the sensor. Temperature limiter will switch off the power from the heater if the temperature in the sauna raises dangerously high (139) due to a malfunction. Instruction manual | Float electric heater Page 5...
Electrical two-way switch connection: If the control unit requires an additional contactor, we recommend a two-way switch connection to distribute the power evenly to the control unit and the additional contactor. Electrical one-way switch connection: Instruction manual | Float electric heater Page 6...
B. 200 mm to the sides, back and front, measured from the cylinder in the outer casing C. 35 mm to the sides, back and front measured from the bottom part of the outer casing Instruction manual | Float electric heater Page 7...
• The heating time is about 45–75 minutes depending on the size of the room and its ventilation. Recommended bathing temperature with IKI heaters is 50–70 degrees. Pouring water on the stones increases the temperature and humidity. •...
Warranty IKI Kiuas Ltd (the manufacturer) assures a warranty to its products as stipulated here, guaranteeing the quality and functionality of the products during the warranty period. The warranty applies to heaters sold and used in Finland. The warranty requires that the buyer follow the instructions regarding the placement of the heater, its installation, use and maintenance as well as those regarding the qualities of the stones used in the heater.
Page 12
The damaged part needs to be stored for inspection. Insurance compensates for the new part, which will be delivered by a public transporter. In all issues concerning warranty contact the store the product was bought from. Instruction manual | Float electric heater Page 11...
Ventilation The ventilation in the sauna room needs to be considered carefully. Proper air-flow allows bathers to enjoy fresh, oxygen-rich air. The air should fully change 6 times an hour. The supply air inlet should be installed on the wall or the ceiling at about 500 mm above the heater. The supply air inlet vent should be 50-100 mm in diameter.
10. Sea-air and a humid climate may corrode the metal surfaces of the heater. 11. Do not hang clothes to dry in the sauna, as this may cause a risk of fire. Excessive moisture content may also cause damage to the electrical equipment. Notes Instruction manual | Float electric heater Page 1...
Page 15
Instruction manual | Float electric heater Page 2...
Page 16
Copyright IKI Kiuas Plc | We reserve the right to make changes Instruction manual | Float electric heater Page 3...
Need help?
Do you have a question about the FLOAT and is the answer not in the manual?
Questions and answers