Summary of Contents for Summer Mill Valley Safety Gate 27960
Page 1
27960 Please read the following instructions carefully. Keep this instruction manual and save for future reference. Tools required (not included): Phillips-head screwdriver and power drill, 7/32" drill bit may be needed. For use with children from 6 - 24 months. Keep small parts away from children.
Page 2
WARNING Children have died or been seriously injured when gates are not securely installed. • ALWAYS install and use gates as directed using all required parts. Install according to manufacturer’s instructions. • STOP using when a child can climb over or dislodge the gate. •...
Page 3
installing the gate STEP 1: Assemble the Support Foot IMPORTANT: This instruction booklet illustrates Top of Stairs gate installation (you may also install the gate between rooms). For TOP OF STAIRS: You must install one of the included Upper One-Directional Stoppers (part G). This step is covered on page 9.
Page 4
installing the gate (continued) STEP 2: Attach Upper & Lower Hinge Brackets NOTE: If baseboards are present: IMPORTANT: If mounting into plaster or drywall, use wall anchors. Using a 7/32" drill bit, drill a pilot hole into the wall, then insert wall anchors prior to mounting hardware.
Page 5
installing the gate (continued) STEP 3: Place Gate Door Into Position...
Page 7
installing the gate (continued) STEP 4: Attaching the Gate Latches...
Page 8
installing the gate (continued) IMPORTANT: If mounting into plaster or drywall, use wall anchors. Using a 7/32" drill bit, drill a pilot hole into the wall, then insert wall anchors prior to mounting hardware.
Page 9
installing gate latches & door stoppers IMPORTANT: FOR TOP OF STAIRS INSTALLATION: Two Upper One-Directional Stoppers are included with this gate. Install the Stopper that prevents the door from opening over the stairs. Gate should never open over the stairs. Baseboard Kit Installation...
Page 10
installing the door stopper IMPORTANT: Be sure to install the door stopper when using at the top of stairs! FINISHED!
Page 11
opening and closing the gate To open and unlock the gate: Press the release To close and lock the gate: Slide the door closed until the buttons on both sides of the door handle and slide open. handle clicks into the latch. removing the gate Swing gate open 90 degrees (until it is perpendicular to opening) and lift gate out of hinge brackets.