Advertisement
Step 7: Once the ice making cycle is nished, the water tray will tilt forward and the remaining water will ow
back into the water reservoir, and then the ice cubes will drop from the ngers.
Step 8 In about 15-35 seconds, the water tray will tilt backward and the ice produced in the previous cycle
will be pushed to the ice reservoir directly. Then the unit will repeat steps 4 to 6 again until the ice
tray is full or there is no water remaining in the water reservoir.
Step 9: Push the ice cube dispenser puncher button (sketch 6) to dispense ice, the indicator will turn on.
Note:
Please put your cup below the ice cube dispenser shoot directly.
Notice:
If the ice is stored in the unit for a long time, the ice may freeze and stick together, which can prevent
any ice from dispensing even if the ice tray is full. If this happens, break up the ice with the included
ice scoop and then try again.
Step 10: Press the ON/OFF button to stop the unit
Step 11: When you push the WATER button, water will dispense from the water outlet.
Note:
Please make sure your cup is below the water outlet, or water will be splashed everywhere
CARING
1. Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When cleaning,
unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside
and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as
acids, gasoline or oil. Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure and the built-in structure, clear of obstruction. Do not
use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer.
3. If the icemaker is reused after a long time, the water pump may not pump su cient water due to an air
block, the de cient water indicator turns on in this case . To correct this press the START button again, then
the icemaker will work normally.
4. To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every 24 hours.
5. If the compressor stops for any reason such as water shortage, too much Ice, power o , etc... Do not start the
system right away, wait 3 minutes, and then re-start the Ice maker.
6. Always use fresh water before starting ice production either at initial installation or after a long shut-o
period.
7. This unit is for home use only, not for outdoor use, if it is necessary for use outside, please make sure the
view window is closed.
5
www.PyleUSA.com
Advertisement
