Advertisement
OPERATING IN STRUCTIONS
Step 1: Plug the machine into an outlet.
Step 2: Open the water reservoir access door and add water as shown in sketch A. You can also add water
automatically by connecting the unit to a water source as shown in sketch B.
Sketch A
Add Water Manually
If the unit is on, and you see the
Step 3: Press the ON/OFF button to start the machine.
Step 4: Water will be pumped into the water tray from the water reservoir automatically, this takes about 30
seconds.
Note:
If no water is pumped into the water tray for over two cycles, and there is enough water in the
reservoir. Then you need to open the drain cap, and let several drops of water run out, then replace the
cap and press the ON/OFF button again to restart the unit.
Step 5: Select the SMALL or LARGE button to choose the ice size you want.
Step 6: The ice making cycle begins, and the ice will be frozen onto the evaporator ngers.
Note:
The ice making time depends on the ambient room temperature.
www.PyleUSA.com
OPEN
Add water manually
indicator, then you need to add water to the water reservoir.
Sketch B
Connect the Unit to a Water Faucet
A. to water pipe
B. to water faucet
C. to Unit
4
Advertisement
