Aligning The Colors; To Align The Colors - Toshiba ColorStream TP50H60 Owner's Manual

CHAPTER 2

Aligning the colors

• This projection TV uses three separate TV tubes: a red one, a green one, and a blue one.
The red, green, and blue images are projected onto the screen where they converge to
form a full color picture. You can see a clear picture only when they converge correctly.
• Convergence may drift over time or if you move the TV. If you can see clear images on
the screen, skip this procedure.

To align the colors

ENTER
DEMO MENU ANT/VIDEO VOLUME
LIGHT
TV
CABLE
MUTE
VCR
1 2
4 5
7 8
100 0
ADV/
PIP CH
MENU/
FAV
ENTER
ADV/
PIP CH
STOP SOURCE
REC TV/VCR
STILL
24
GETTING STARTED
This adjustment should be made after the TV has been on for at least 30
minutes.
CHANNEL
To check and align the colors
1
2
RECALL POWER
TV/VIDEO TIMER
3
CH
6
9
3
VOL
CH RTN
ENT
FAV
4
PLAY PIP
REW FF
LOCATE SWAP
5
Press MENU, then press
the PICTURE menu appears.
Press (or ) until "CONVERGENCE"
is highlighted.
Press or to display the center
CONVERGENCE menu.
If alignment is correct, there will be one
vertical and one horizontal white line.
If you see separate colored lines, you
have to align the colors.
Press ENTER to select "RED" or "BLUE."
The selected color is highlighted.
Press the " (up)", " (down)", "
(left)" or " (right)" button to converge
the red or blue line into the green line.
When color convergence is correctly
adjusted, you will see two single white
lines.
or until
PICTURE AUDIO SET UP PREMIUM
CONTRAST
BR I GHTNESS
COLOR
T I NT
SHARPNESS
PICTURE AUDIO SET UP PREMIUM
F L ESH TONE
NO I SE REDUCT I ON
CONVERGENCE
RED BL UE
PUSH ENTER
TO SE L ECT COL OR
PUSH EX I T
TO SELECT POS I T I ON
RED BL UE
PUSH ENTER
TO SE L ECT COL OR
PUSH EX I T
TO SELECT POS I T I ON
RED BL UE
PUSH ENTER
TO SE L ECT COL OR
PUSH EX I T
TO SELECT POS I T I ON
SBS PREFERENCE C.CAPTION
To end push EXIT
SBS PREFERENCE C.CAPTION
On
On
START
PUSH
To end push EXIT
To end push EXIT
To end push EXIT
To end push EXIT