Starting Up - Tajfun Planina RCA 380 Operating Instructions Manual

3.3. STARTING UP:

Before each machine startup, it is necessary to check the chain tension and readjust it if necessary!
A too loose chain can induce vibrations, which unfavorably affect the drive belt's operation. Increased
vibrations can also cause damages to the drive belt. A new cutting chain needs to be retensioned after approx.
half an hour of use. Please check.
Remove all wood remains and other particles from the splitting chute, before starting the machine!
Check the oil levels of the hydraulic system and cutting chain lubrication system, before starting the machine!
Before starting the machine, make sure to loosen the conveyor belt, by moving the Discharge Conveyor from
vertical to horizontal position using the hand winch (3-Figure: 3). Otherwise damages to the belt can occur
during the extension procedure!
RCA 380:

Examine the machine and equipment for faults and check the chain lubrication.
 Place the tractor manual throttle handle in lowest position.

Lift the machine cover (B-Figure: 1a) to activate the safety switch and disengage all major machine
functions.

Slowly engage the P.T.O. shaft drive and start the machine.
 Set the required rotating speed of P.T.O. shaft (420 RPM), using the manual throttle handle.

Lower the machine cover.
RCA 380 E:

Examine the machine and equipment for faults and check the chain lubrication
 Plug the machine to electric power source

Turn on the Main Switch (R-Figure: 1)
 Lift the machine cover (B-Figure: 1) to activate the safety switch and allow easier starting of the electric
motor
 Push the "Start-Stop" switch (green button) (S-Figure: 1) and immediately check the rotating direction
of the cutting chain: in case of wrong cutting chain direction, immediately stop the drive (push the red
button on the "Start-Stop" switch and change the rotating direction of the electric motor (Chapter: 3.)
 Lower the machine cover
10