How To Mount Js-960Wp On The Wall And Under Counter - Panasonic JS-960 Series Service Manual

9. How to Mount JS-960WP on the Wall and under Counter

This document is an installation instruction for POS Workstation (JS-960WP) (mentioned as POS in the following)
POS can be mounted in counter, table and wall by using mounting brackets which meet VESA Type's spec.
Back
Place for mounting bracket
100
1. Attentions regard to the environment for setting-up.
Please don't install the POS near a heater or in direct sunlight.
Please don't install the POS in places with extreme temperature changes or high humidity.
Please don't install the POS outdoors or in places with lots of dust or smoke.
Please don't install the POS in places with strong magnetism or receivers of TV, radio...etc.
Please install the POS in places where room temperature between +5°C~+40°C = 41°F~104°F.
When install near other POS machine, other machines and roof, please reserve 10cm = 4" or above in left,
right, front, back and upper side. Please also reserve 6cm = 2.5" or above when set up on a wall.
Please don't obstruct POS Port access at upper rear panel.
Please install POS in permanent, stable, solid location not susceptible to any physical damage.
Please don't install the POS in places leaking or be poured by liquid or spray.
2. POS installation
There're no mounting brackets (brackets, screws...etc.), drop-prevention wire in the POS. Here explaining the
attention items for preventing following and dropping after installing the POS.
2.1. Assemble mounting brackets on POS
Please obey the attention items below.
Please use mounting brackets which meet VESA Type's spec.
There're 4pcs（M4 P0.7） fixing screws for mounting bracket. The screw length under screw head minus
the thickness of mounting bracket (the portion for fixing screws on mounting bracket) should be equal to
8mm. (For example, if the portion for fixing on mounting bracket is 2mm thick, the length of screw under
screw head should be 10mm.）
（Recommended screw torque 950 N•mm｛9.7 ㎏・cm｝±10％）
To avoid looseness, please use flat washer with fixing screw or use screw with spring washer.
Torque driver and torque wrench can limit the torque under decided number. Please refer to the
recommended torque to choose suitable torque driver or torque wrench.
Because it's difficult to manage torque when using impact driver or electric driver and will cause damage to
screw, bolt or POS machine, please don't use impact driver or electric driver.
Left Side
Outlet
Place to fix
drop-prevention wire
M4 P0.7
7mm
4 M4 P0.7
8mm
Operation
Bottom
-9-1-