Viewing The Digital Signal Meter; Viewing The System Status - Toshiba 52HMX95 Owner's Manual

Viewing the digital signal meter

You can view the digital signal meter for the ANT 1 and ANT 2
digital TV input sources only.
To view the digital signal meter:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER.
Setup
Installation
Sleep Timer
On/Off Timer
PC Settings
HDMI 1 Audio Auto
HDMI 2 Audio Auto
Slide Show Interval 2 Sec
Navigate Select CH RTN Back EXIT Exit
3. A new set of Installation menu icons will appear on-screen,
as shown below. Open the Terrestrial menu, highlight
Signal Meter, and press ENTER.
Terrestrial
Input Configuration
Channel program
Channel Add/Delete
Signal Meter
Navigate Select CH RTN Back EXIT Exit
4. Press yzx • to select the antenna input and digital
channel whose signal you want to check.
Note: The physical digital channel number listed in the Signal
Meter screen may not correspond to a virtual TV channel
number. Contact your local broadcasters to obtain the RF
channel numbers for your local digital stations.
Signal Meter
Signal Locked
0
Peak 0
Antenna 1
Physical Digital Channel 13
Virtual Digital Channel N/A
Done
To close the screen and return to the Terrestrial menu:
Highlight Done and press ENTER.
To return to normal viewing:
Press EXIT.
Chapter 6: Setting up your TV

Viewing the system status

To view the system status:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. A new set of
Installation menu icons will appear on-screen, as shown
below right.
Setup
Installation
Sleep Timer
On/Off Timer
PC Settings
HDMI 1 Audio
HDMI 2 Audio
Slide Show Interval
Navigate
3. Open the System Status menu, highlight System
Information, and then press ENTER.
4. Press x • to scroll through the menu bar to check the
Product Information and Software Version.
System Information
IEEE1394 GUID:
To close the screen and return to the Installation menu:
Highlight Done and press ENTER.
To return to normal viewing:
Press EXIT.
Restore Factory Defaults
To restore all settings and channels to their factory default
values:
1. Follow steps 1–3 above.
2. Press x • to scroll through the menu bar to select Factory
Defaults.
3. Enter your PIN code (or 0000 if no PIN code has been set).
4. Highlight Yes and press ENTER. The TV will turn off
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the restore process.
System Information
To cancel the reset:
Highlight No and press ENTER.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
System Status
System Infomation
Auto
Auto
2 Sec
Select CH RTN Back EXIT Exit Navigate
System Information
Product Information
Software Version
Brand: Toshiba
Model: 52HMX95
Mar 9 2005 - 12:37:10
00003914-28343803
Done
Press YES to confirm. After the TV
turns off, unplug it and plug it dack
in to complete the reset.
Yes No
Select CH RTN Back EXIT Exit
0.3.0
FW:0.12
Sub:47
Done
57