Installing The Fan Without The Light Kit (Optional) - PROGRESS LIGHTNING AirPro P250002 Installation Manual

NOTE: The metal light cover included with your
fan is an option to replace the plastic shade for
the light in the event that you prefer not to use
the light feature of your fan.
1. Disassemble the plastic shade from the light
kit. You can keep the plastic shade for future use.
(Fig. 15)
2. Installing metal light cover to the LED light
kit with the two screws previously removed.
(Fig. 15)
3. Remove the 2 screws from the mounting plate.
(Fig. 16)
4. Place the LED light kit to the mounting plate.
Align the mounting holes with the holes in the
light kit and mounting plate, and fasten using the
two screws previously removed. (Fig. 16)
5. Slide the decorative ring up to light kit
assembly and place the key hole on the
decorative ring over the two screw on the light
kit, turn decorative ring until it locks in place at
the narrow section of the key holes. (Fig. 16)
NOTE: Do Not connect the 2-pin wire
connectores before installing the metal light
cover.
Installing the Fan without the Light Kit
LED Light kit
assembly
Plastic
shade
Screws
LED Light kit
assembly
Metal light
cover
Screws
Figure 15
Wire connector
Decorative
ring
Figure 16
(optional)
Mounting
plate
Screws
10.