Installing The Light Kit - PROGRESS LIGHTNING AirPro P250002 Installation Manual

Before starting
CAUTION:
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
NOTE: If you do not wish to install the light
kit, skip steps 9 and proceed to step 10.
1. Remove the 2 screws from the mounting plate.
2. While holding the LED light kit under the fan
motor assembly, make the 2-pin wire connections:
(Fig. 13)
- White to white
- Black to blue
3. Place the LED light kit to the mounting plate.
Align the mounting holes with the holes in the
light kit and mounting plate, and fasten using the
two screws previously removed. (Fig. 13)
4. Slide the decorative ring up to light kit
assembly and place the key hole on the decorative
ring over the two screw on the light kit, turn
decorative ring until it locks in place at the narrow
section of the key holes. (Fig. 14)
9.

Installing the Light Kit

installation,
Wire connector
LED Light kit
assembly
Figure 13
Mounting
plate
Decorative
ring
Screws
Figure 14
Screws