Manual Defrost; Cleaning, Care & Maintenance; Cleaning The Condenser - Anvil VRX1200/330 Manual

Parameter Name
Unit of Measurement
=22
Compressor Operation
=23
During Probe Failure
Compressor 'On'
=24
Duration
Compressor 'Off'
=25
Duration
Initial Defrost After
=34
Startup
Minimum Temperature
=38
Alarm

Manual Defrost

The appliance will automatically run a defrost cycle every six hours.
Note: The cycle starts from the time the appliance is initially powered up.
To manually defrost the appliance:
1. Press and hold the DEFROST
2. The defrost cycle will start immediately and the Defrost LED illuminates. The defrost will last a maximum of 30 minutes.
Note: Starting a manual defrost also resets the automatic defrost timer.
The next automatic defrost will start six hours after the manual defrost has finished.
3. Waste water is collected in the waste water tray.
Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• Take care when cleaning the rear of the appliance. Sharp edges can cut.
• A RWA agent or qualified technician must carry out repairs if required.

Cleaning the Condenser

Periodically cleaning the condenser can extend the life of the appliance.
RWA recommend that a RWA agent or qualified technician clean the condenser.
Set whether the temperature is displayed in Centigrade or Fahrenheit
Set whether the compressor runs or remains Off during a temperature probe failure
Set the length of time the compressor runs during a temperature probe failure
Set the length of time the compressor remains Off during a temperature probe failure
Set whether the appliance starts a defrost cycle 10 minutes after startup or after the time
programmed in parameter d8 (Defrost Cycle Time Intervals)
Set the display to flash should the inner temperature of the appliance drop beyond a specified
point from the programmed operating temperature
button for 5 seconds.
Description
3
UK
Range
Centigrade (0 ) or Fahrenheit (1 )
Compressor runs (1 )
Remains Off until fault fixed (0 )
Runs intermittently with
parameters =24 and =25 (2 )
1-99 minutes
1-99 minutes
Begins 10 minutes after startup
(0 ) or when programmed (1 )
1°C to 50°C