TEC B-670 SERIES Owner's Manual page 17

8. LOADING THE MEDIA
5. Turn the Lock Levers of the Media Holders to the unlock position and readjust the Media position to
the center. Then lock the Media Holders securely with the Lock Levers. Fit the Media Guides to the
Media. Tighten the screw
Media Guide
Media Guide
NOTE: Set in the bushes of the Holder Shaft into notches of the Holder Stand securely.
6. The black mark/feed gap sensor is selectable between the fixed type and the movable type by
changing the DIP switch (Refer to page 4-1). When the fixed type is selected, the black mark sensor
is located at the center of the media and the feed gap sensor is at 10 mm left to the black mark sensor.
The movable sensor can be located anywhere between the left end of the effective print width and
the fixed sensor.
After changing the sensor type, the sensitivity of the sensor must be adjusted. In this case call a
TOSHIBA TEC authorized service representative.
firmly.
Lock Lever
Screw
Holder Shaft
E8-2
ENGLISH VERSION EO1-33016
Media Holder
Media
Holder Stand
Bush
8. LOADING THE MEDIA
Media Holder
Notch
Fig. 8-3