Take-Up Turntable (990227) For Series 14 - TANDBERG 15 Series General And Technical Information

990227
215743
200549
M307
209658
202230
218415
990229
200628
202740
M355
p
4.2.4 Take-Up Turntable (990227) for series 14/15
See fig. 4.9. The take-up turntable assembly is put
together as follows:
Place the helical spring 218415 and the friction disc
209658 over the bearing housing 200628 with one end
of the spring resting in the cylindrical groove of the
bushing 202230. The tongue on the bushing should
point at the rear of the tape recorder. Push the fric-
cz,s
vi
211339
Fig. 4.9 Take-up turntable assembly, Series 14/15.
tion disc 205698 down, with the delrin studs on the
bushing passing through the notch in the upper
clutch lever 990229. Press the lower clutch lever
202740 against lower mounting plate 990216 by means
of a screwdriver. The spacing between upper and
lower levers will now be approx. 6 mm (1/2"). Turn the
bushing 900 counterclockwise until the two delrin
studs are locked by the two claws on lower clutch
lever.
Put on the mylar washer 215743, press the flange
200549 down into the upper end of the housing and
insert the turntable shaft through the housing. Move
the operating lever 990225 to position fast reverse
winding, whereby the friction disc is pressed down
by upper clutch lever causing the turntable to rest on
the flange. Put the teflon washer M355 on the turn-
table shaft and fasten the counter pulley 211339. The
turntable should now more freely with an axial slack
of approx. 0.1 mm (4 mil).
202740
209658
202230
990229
Fig. 4.10 Take-up friction disc with clutch levers.
209658
215743
Fig. 4.11 Friction disc with mylar sheet.
11