Advertisement
4. CONTROL PANEL
5. OPERATION
5.1.
Duty Cycle
5.1.1.
After 5 starts let the unit rest for 15 minutes.
5.2.
turn of turn off headlights, air conditioning, audio etc.
5.3.
BuZZER
5.3.1.
intermittent buzzing indicates the e/stArt is ready to start vehicles.
5.3.2.
continuous buzzing means there is an error.
5.4.
STANDARD MODE
5.4.1.
in most situations the weak battery on the vehicle can fully recharge the e/stArt.
5.4.2.
connect clamps to the battery terminals, e/stArt will turn on automatically and the display will show the voltage of the vehicle's
battery, see fig.1.
5.4.3.
Press ON/OFF and the E/START starts to recharge itself. The display shows the E/START's percentage, see fig.2.
5.4.4.
After the ignition sign appears, see fig.3, turn on the engine.
5.5.
OVERIDE - Battery Fitted to Vehicle
5.5.1.
in some situations the e/stArt may fail to start the car because the vehicle's battery is too weak. Press on/off for a few seconds to
activate BY PASS MODE. Wait until beep is heard to confirm activation.
5.5.2.
After the ignition sign, fig.3 appears, turn on the engine as soon as possible.
If the vehicle battery is too low the back up battery automatically kicks in to recharge the unit.
5.6.
PRECHARGE MODE
5.6.1.
The E/START can be fully recharged by its own back up lithium battery pack, before it is fitted to the vehicle.
5.6.2.
If the E/START is under 80% of charge, shown on the display, see fig.2, press ON/OFF for a few seconds and the back up battery
begins to recharge the e/stArt.
5.7.
BYPASS - No Battery fitted
5.7.1.
the e/stArt's battery needs to be at 80% of charge or more.
© Jack sealey limited
Original Language Version
e/stArt800HY | issue:2 21/07/17
Advertisement
