NETGEAR AirBridge WBC502 Hardware Installation Manual page 14

Insight Instant AirBridge WBC502 Hardware Installation Guide
Table 1. Status LEDs
LED Description
Power LED Solid amber. The AirBridge is powered on.
Blinking amber. The physical Reset button was pressed and the AirBridge is resetting to
factory default settings or user default settings.
Off. Power is not supplied to the AirBridge.
LAN1 LED Solid amber. The port is connected to the supplied power adapter, and the LAN port on
the power adapter is connected to an Ethernet device.
Off. No port link is established.
LAN2 LED Solid amber. The port is directly connected to another Ethernet device.
Off. No port link is established.
WLAN LED AirBridge Master
operation mode
AirBridge
Satellite
operation mode
Access Point
operation mode
Client Bridge
operation mode
Signal strength On an AirBridge that functions either as a satellite or a client bridge, a single SSI LED lights
indicator (SSI) LEDs to indicate the strength of the signal for the WiFi connection, either between the satellite
(AirBridge Satellite and the master or between the client bridge and the access point.
or Client Bridge
operation mode)
Hardware Overview
Solid amber. One or more 5 GHz SSIDs are enabled.
Off. All 5 GHz SSIDs are disabled.
Note: If the AirBridge mode is enabled, a single 5 GHz SSID only is
supported. You cannot disable that SSID.
Note: If the management mode is NETGEAR Insight, a single 5 GHz
SSID only is supported.
Solid amber. The satellite is connected to the master.
Off. The satellite is not connected to the master.
Solid amber. One or more 5 GHz SSIDs are enabled.
Off. All 5 GHz SSIDs are disabled.
Solid amber. The client bridge is connected to the access point.
Off. The client bridge is not connected to the access point.
Right SSI LED solid green. The signal for the WiFi connection is strong.
(The RSSI is better than –70 dBm.) The left and middle SSI LEDs are off.
Middle SSI LED solid amber. The signal for the WiFi connection is
moderately good. (The RSSI is between –70 dBm and –85 dBm.) The
left and right SSI LEDs are off.
Left SSI LED solid red. The signal for the WiFi connection is weak. (The
RSSI is weaker than –85 dBm.) The middle and right SSI LEDs are off.
All SSI LEDs off. No WiFi connection is established or the signal strength
cannot be determined.
14 Hardware Installation Guide