Westfalia 96 11 10 Instruction Manual page 17

To enable the radio switch and the receiver to communicate
together, first a command signal has to be emitted.
Learning the radio controlled lantern, Type ED102
1. To send the command to the
lantern hold the remote switch and
the lantern close together. Press
the learning key that way (prefera-
bly from the side), so to be able to
notice the status of the built-in
LED.
2. Press down the learning key as
long as the LED starts flashing.
Now you have totally 30 seconds
to emit the command.
3. Press down the OFF section of the
rocker switch for approx. 3 seconds
and observe the LED of the learn-
ing key. The LED of the lantern
starts glimmering and after some
seconds the LED turns off. This
indicates that the command signal
has been emitted.
Operation
12
Learning Key
OFF