Advertisement
Re-insert faceplate
7
assembly into housing
Carefully insert the assembly back into the POGO's head
cavity, starting with the end that has attached wires.
Make sure all the wires are tucked inside the cavity.
Then place the other end in until the faceplate is flush.
Apply new faceplate
9
label
Peel off the label's protective backing. Carefully apply
it by lining up the charging port as a guide along with
the corners tp ensure the label fits completely inside
the raised border of the faceplate.
START HERE
Bluetooth
Conversion for
POGO Pro
UNINSTALL POGO TURF PRO APP
You must uninstall the current app
for your POGO Pro and use the new
'TurfPro Mobile' app once your POGO
Pro is converted to Bluetooth
Make sure this GPS
antenna (cream-
colored square) is
facing the top of
the POGO.
Insert and tighten the
8
4 faceplate screws
Insert screws
and tighten until
faceplate is
snug. DO NOT
OVERTIGHTEN.
You're done!
If you haven't already,
go install the TurfPro
Mobile app.
Here's what you'll need:
Bluetooth conversion kit:
• Bluetooth circuit board
• Screw
• 3/32" hex wrench
• Replacement faceplate
label
POGO Pro
Ready to begin? Go to step 1
Make sure the faceplate
is flush and all 4 screw
holes line up.
What Can You Now Do
With a Bluetooth
Connection to Your POGO?
• Connect to the POGO
automatically.
• Stay connected to the POGO while
being connected to the Internet
(cellular or Wifi)
• Sync your data to POGO TurfPro
Cloud at any time, without
disconnecting the POGO.
• Show your location and the
location of samples on a satellite
map in the app in real time.
#1 Philips screwdriver
Hobby or
utility knife
Advertisement
