Pogo Pro Start Here

1
Remove faceplate label
Use a utility
knife to
carefully pry
up a corner
of the label.
Slowly and
carefully
peel off the
entire label.
Remove faceplate
3
assembly from housing
Grabbing the faceplate by the
charging port or the edges, carefully
remove the faceplate assembly.
Be careful to
not damage
connected
wires.
The WiFi board which will be replaced.
Attach Bluetooth board
5
to board assembly
Carefully line up the pins with the pin
holes for both the 6-pin and 8-pin
blocks and press down. You'll feel the
board stop when completely inserted.
Place the faceplate
assembly upside down
on a flat surface to
expose the circuit boards.
Don't over-
squeeze!
Remove 4 screws
2
to detach faceplate
Using a #1 Philips
screwdriver, remove all 4
screws securing the faceplate.
Remove hex screws
4
securing WiFi board
Using the hex wrench, remove the 2
screws holding the WiFi board in place.
Get ready to install the new
Bluetooth board
Removing the WiFi board exposes 2
blocks of pins, one 8-pin block, and
one 6-pin block. The pin holes on
the Bluetooth board will line up
with these.
Secure Bluetooth
6
board with screw
Do not overtighten! Just
enough to hold the
board in place securely.
Your new
Bluetooth
board.