Toshiba T2N Instruction Manual page 38

Table 4.5
Error
Normal complete
Local port fault
Local port standby
Timeout
Length error
Port mode error
MAC/IP not set up
Transmission prohibited state
Format error
Opened
Unopened
Incorrect socket identifier
Incorrect control request
specification
LAN controller driver error
Detailed Information (Ethernet Port Error Responses) PART1
Code
Description
0001H Request completed normally
0002H The local port is in down mode
0003H In standby mode data transmission (socket interface transmission or PC link
protocol transmission) was requested.
0020H Timeout occurred during TCP open processing or receive processing, or during
UDP receive processing.
0030H Incorrect send data length
0040H One of the following requests was issued in a mode other than standby mode:
a. Parameter setup, b. MAC address setup, c. Reset
0050H
Occurs if the MAC address or IP address is not set up.
0060H • Occurs if a PC link request was issued from the T2N in run mode in the
message transmission prohibited state.
• Occurs if a socket open, close, send, or receive request is issued by the T2N
in run mode in the socket interface transmission prohibited state.
0070H Occurs when there is a format error in the request text.
0071H Port number error
0072H Request code error
0073H Time setting: Year
0074H Time setting: Month
0075H Time setting: Day
0076H Time setting: Hour
0077H Time setting: Minute
0078H Time setting: Second
0080H Occurs if an open request is issued for an already open socket.
0081H • Occurs if send, receive, or close request is issued for an unopened socket.
• Occurs if send, receive request is issued for TCP socket during receiving
CLOSE request (RCLOSE bit is 1).
0082H Occurs if the socket identifier is out of range (1 to 8).
0083H Occurs if a request that was prohibited by an operating mode control request is
issued.
• Occurs if a run request is issued in run mode.
• Occurs if a standby request is issued in standby mode.
• Occurs if a run request and a standby request are issued at the same time.
0090H Occurs if the setting of the local port IP address and port number in the area
reserved for transmission fails.
0091H • Error in the TCP or UDP protocol (such as a transmission phase error)
• Occurs if send request is issued for TCP socket that remote port is down and
NOACK bit is 1.
0092H • Occurs if the setting of the remote port IP address in the remote port
information area (the NETDATA table) fails.
• Occurs if the remote port IP address network address differs from the local
port IP address network address.
37
6 F 3 B 0 3 6 2