Vibicom VB-101 Installation And Operation Manual page 32

Chapter 2 Installation and Setup
Changes or modifications made to this device that are not expressly approved by
Caution
the party responsible for compliance could void the user's authority to operate
the equipment.
Caution
Remove the power cord from a power-supply unit before installing it or remove it
from the device. Otherwise, as a result, the power supply or the device could be
damaged. (The device can be running while a power supply is being installed or
removed, but the power supply itself should not be connected to a power
source.)
The unit is designated to operate in environments of up to 70 degrees ambient
Caution
temperature.
For AC units, under some conditions the housing of the unit might get hot and
direct touch should avoid.
Installing or removing a SIM card while the modem is operating can damage the
Caution
modem. Make sure either the modem is disabled (cellular disable) or VB-101 is
turned off, before manipulating the SIM card.
Laser Safety
VB-101 includes Class 1 lasers. For your safety:
• Do not look directly into the optical connectors while the unit is operating.
The laser beams are invisible.
Warning
• Do not attempt to adjust the laser drive current.
The use of optical instruments with this product will increase eye hazard. Laser
power up to 1 mW at 1300 nm and 1550 nm could be collected by an optical
instrument.
Use of controls or adjustment or performing procedures other than those
specified herein may result in hazardous radiation exposure.
Grounding
For your protection and to prevent possible damage to equipment when a fault
condition, e.g., a lightning stroke or contact with high-voltage power lines, occurs
on the lines connected to the equipment, the VB-101 chassis must be properly
grounded (earthed) at any time. Any interruption of the protective (grounding)
Grounding
connection inside or outside the equipment, or the disconnection of the
protective ground terminal can make this equipment dangerous. Intentional
interruption is prohibited.
2-2 Safety Information
Installation and Operation Manual
VB-101