Reconfiguration Of Single-Line Diagram And Inspection- Maintenance Mode - ABB RELION REB500 Commissioning Manual

Section 4
Maintenance
xx
6. Confirm the new address by pressing the enter key.
7. Leave the maintenance menu by navigating to Exit and pressing the enter key.
After installing the new hardware, all components that are not included in the self supervision
have to be checked according to the normal commissioning procedures.
4.3 Reconfiguration of single-line diagram and inspection-
maintenance mode
For detailed information about reconfiguration (activation or deactivation of bays and
switchgear objects) and the inspection-maintenance mode, see
1KHL020820 Reconfiguration of single line diagram and inspection- maintenance mode .
16
fourth octet → Device Id of the unit
In order to get a complete list of Device Ids the HMI500 shall be opened → Menu item
Tools/Reports/Device Id allocation
© Copyright 2019 ABB. All rights reserved
1MRK 505 401-UEN B
GUID-917FE8FE-22F4-4CEB-AF30-D36CA04EBAA2 v1
REB500 Application Note
Distributed busbar protection REB500
Commissioning manual