Advertisement
2
Installing the Horn
Parts needed for this procedure:
1
Horn
1
Horn switch
1
Horn button (rubber)
1
Bolt (5/16 x 3/4 inch)
1
Flange nut (5/16 inch)
Procedure
1. Install the horn bracket to the tab, under the platform,
with a bolt (5/16 x 3/4 inch) and flange nut (5/16 inch)
as shown in
Figure
Note: Rotate the horn so it faces toward the back of
the machine.
1
2
3
1. Flange nut (5/16 inch)
2. Horn
2. Insert the horn switch through the hole in the
steering-column tower
1.
Figure 1
3. Bolt (5/16 x 3/4 inch)
(Figure
2).
1
1. Horn switch
3. Secure the horn switch to the tower by threading on
the rubber horn button
4. Locate the wire-harness connectors inside the steering
column tower.
5. Plug the wire-harness connectors labeled "horn" into
the horn and switch.
6. Secure the wire harness.
Note: When routing the wires, ensure that the
operation of the tilt steering does not damage the
harness or pull on the wires.
7. Connect the battery; refer to your Operator's Manual.
3
Testing the Horn Function
No Parts Required
g021716
Procedure
Confirm that the horn sounds when you press the horn
button and stops when you release it.
Note: If the horn does not sound, ensure that the
wire-harness connectors are secure.
2
Figure 2
2. Horn button
(Figure
2).
2
g021715
Advertisement
