Table of Contents
Advertisement
Chapter 4 -- Installation--1st Time Device Installation in Windows
Figure 4-5
Install the Software Automatically
As seen in this Figure, if you have your Gamry Instruments software CD (or DVD), insert it in your computers
CD (or DVD) drive, select Install the software automatically, then select Next.
The Windows Device Manger will install the required files from the CD.
On occasion you may desire to change the USB port which is used to connect the eQCM 10M to your
computer. The same procedure discussed above may need to be followed for each USB port on your
computer, depending upon your operating system requirements. Once the eQCM 10M has been connected to
a port, removing and reconnecting to that port will no longer require any device installation. If you expect to
switch between multiple USB ports on your computer, it is recommended to go through each of the ports in
sequence while your installation CD is handy. Once you have done this, store the installation CD in a safe
place.
This above process must also be repeated a second time for the eQCM 10M. The eQCM 10M actually appears
as two devices due to the design of the internal electronics. The second device appears as "Gamry Instruments
eQCM Instrument (Command)."
4 - 6
Advertisement
Table of Contents
