Head Kandy The Party Animal Quick Start Manual

The Party Animal
Beach Crimper
PRODUCT PROFILE:
- 70W 110v/220v dual voltage
- 60 minute auto shut off
- 240-450F temperature range
- Uses infrared heat and emits negative
ions to minimize damage, boost shine,
smooth frizz, and retain moisture
- Unique three barrel design with an extra
wide middle plate creates deep, smooth,
long lasting waves
COOL TOUCH TIP
HEATED
CERAMIC PLATE
TEMPERATURE
BUTTONS
HANDLE LOCKING
MECHANISM
360° SWIVEL CORD
OPERATION:
1. Insert power plug into an electrical outlet,
ensuring that the plug matches the
socket.
2. Press the power button to turn on. Select
desired temperature by pressing the + or
- buttons. Allow 60 second heat up time.
3. Once the hair styling process is
complete, press the power button and
hold it down until your appliance shuts
off. Unplug it, and allow your crimper to
cool prior to storage.
4. Never use this appliance near water.
5. Safety precautions included, but not
limited to those stated herein, should be
observed at all times while appliance is
in use, especially if the appliance is used
around children.
6. The first time using this appliance there
may be a slight burning smell or very
light smoke which is caused by the
residual oil on the PTC heater metal
parts burning off when heated. It is
normal and safe to use.
TEMPERATURE
RECOMMENDED HEAT SETTINGS:
DISPLAY
Delicate, thin, fine hair
Average to thick or color treated hair
Thick, wavy, or coarse hair
IMPORTANT! When using this styling tool
for the first time, select the LOWEST heat
setting on one small section of hair for 5-8
seconds. If you want to use a higher heat
setting, GRADUALLY increase the
temperature. Never style for the first time
on a high setting as this may damage your
hair. Use only as much heat as you need
for effective styling.
250° - 320°
340° - 390°
390° - 440°
INSTRUCTIONS FOR USE:
1. Use on dry hair only.
2. Brush hair prior to use.
3. Work from the scalp to the ends of hair.
Starting at the roots, lightly clamp a
small section of hair between the
barrels. Hold the crimper in this position
for a few seconds, depending on your
hair type. Release the handles and let
the hair slip out. For continuous waves,
match the outermost wave of your hair
with the barrel and hold in position
again for a few seconds. Repeat the
process until desired look is achieved.
4. Allow your hair to cool before running
your fingers through it.
5. To minimize damage, always use a
thermal protectant prior to styling with a
heated hair appliance.
6. Finish the look with a few spritzes of Air
Head texture spray (sold separately) to
set the style.
NOTE: Smooth curly hair by gently pulling
the crimper through hair to relax curls.
WARNING: To avoid scalding, DO NOT
TOUCH the ceramic plates while your crimper
is heating up, during operation, or after use