Maintenance And Care - Redback EC20 Operating Manual

EC20 / EC50
RedBack_Charger EC20-EC50_ 2016 8:33 08
 To remove, press the release button (1.)
and pull out the battery (2.).
 Pull out the mains plug.
Fault messages
If the LED flashes red after the battery is
inserted into the charger, there is a fault
with the battery or charger.
– The battery is too hot or too cold.
The charging process starts when the
battery reaches the charging
temperature (0 °C...40 °C).
– If after some time the LED still flashes
red:
Remove the battery from the charger.
Check contacts at charger and battery
for
necessary. Reinsert battery. The battery
is faulty if the same display appears
contamination and clean
again. Replace the battery or have it
checked in a professional workshop.
– If this fault message is also displayed
with a different battery, then there is a
fault with the charger. Have the charger
checked by a professional workshop
Information to ensure a long
battery service life
Lithium-ion batteries do not exhibit the well
known "memory effect". Nevertheless,
before a battery is recharged, it should be
fully discharged and the charging process
always runs to the end.
If the batteries are not used for a prolonged
period, store batteries partially charged
and in a cool location (10–25 °C).
NOTE
Reduced operating times after recharging
indicates that the battery is worn out. The
battery must be replaced.

Maintenance and care

WARNING!
Before performing any work, pull out the
mains plug. Do not use water or liquid
detergents.
Cleaning
 Remove dirt and dust from the housing
with a paintbrush or dry cloth.
Storage
 Store the charger in a dry and frost-free
place (10-25 °C).
 Store the battery and the charger
if separately.
Repairs
Repairs may be carried out by an
authorized customer service center only.