Perrycraft Sportrek Installation Instructions

ROOF RACK INSTALLATION INSTRUCTIONS (ALL RAIL LENGTHS)
1549 US Highway 21 South
Sparta, NC 28675
336-372-2545
customerservice@perrycraft.com
www.perrycraft.com
ROOF RACK INSTALLATION INSTRUCTIONS
(ALL RAIL LENGTHS)
Before contacting/returning this product to your place of purchase, please contact
Perrycraft, Inc.® at 336-372-2545 for any technical questions, problems, missing
parts, etc., upon opening your product and verifying all components are present.
RETURNS: Any product to be returned must be returned to the place of purchase, and is
subject to the seller's returns policy. DO NOT return to Perrycraft unless instructed to do so
in writing.
NOTE: Perrycraft's products are manufactured to be installed into the skin of the roof panel
of vehicles. They are not designed to line up or be installed at the factory fitment points
available on some vehicles.
NOTE: The included hardware pack contains screws for securing this rack to a sheet metal
roof or metal surface. To install this rack on fiberglass or composite camper tops, tonneau
©
covers, or Jeep tops, please contact your seller to purchase hardware pack HWSTTC-UV, or
call 336-372-2545 to purchase directly from Perrycraft, Inc.®
NOTE: Perrycraft, Inc.® manufactures racks and rails that are size specific, not vehicle
specific. Therefore, the bow of the rails (front to back) may need adjusting. Place the rails on
the roof in the desired location. Ideally, the rails should match the roof curvature. The ends
of the rails should touch the roof and the center should be no more than 1/2" off the roof
surface. The rails can be adjusted (more bow or less bow) by securing one end of the rail to a
solid surface, holding the other end, and applying moderate pressure to the rail where
adjustment is needed.
Retain these instructions. They are useful if contacting Perrycraft for information, parts, or
service.
ITEMS NEEDED (NOT INCLUDED)
Measuring Tape

Marker

Drill

1/8" Drill Bit

Phillips Screwdriver

Rag and Cleaner for roof

CONTENTS:
2 – Side Rails (Rails will be 1" shorter than last two numbers of part number (ex.

ST3649-B, rails are 48")
2 – Cross Bars (Cross bars will be 7" shorter than first two numbers of part number

(ex. ST3649-B, cross bars are 29")
 4 – Stanchions (2 Left – 2 Right) (Stanchions can be placed in numerous
configurations; 4 facing forward, 2 forward-2 back, 4 back)
 1 – Hardware pack
4 – #8 x 1/2" Pan Phillips – Blunt End
o
8 – #10 x 1/2" Truss Phillips – Waxed (10 screws for 49" rails, 12 screws
o
for 59" rails, 14 screws for 69" rails, 16 screws for 79" rails)
2