Advertisement
Quick Links
Advertisement
Related Manuals for LinTronic RELAY 208
Summary of Contents for LinTronic RELAY 208
- Page 1 LINTRONIC RELAY 208 LinTronic RELAY 208 Updated: 130622 http://lintronic.dk...
- Page 2 LINTRONIC RELAY 208 Curtains control LinTronic Relay 208 has been carefully designed to control curtains, blinders, screens, lifts, motors, etc. IMPORTANT If you are controlling ac-motors, make sure you always select "mode 01-32". Mode 01-32 has automatic protection against UP and DOWN beeing active at the same time, which will destroy the motor.
- Page 3 LINTRONIC RELAY 208 Switch / relay controlled curtains Typically powered by 12 volt 12 volt 0 volt RELAY 208 DOWN C A R C A R 220 vac 12 volt power supply http://www.lintronic.dk...
- Page 4 2 = Ground 3 = Open 4 = Close Connector for IR receiver IR receiver can be removed or left working in parallel with the Relay 208, using the original remote control. RELAY 208 DOWN C A R C A R http://www.lintronic.dk...
- Page 5 LINTRONIC RELAY 208 Relays (controlling motors) Suggested mode: 1-32, Up/Down CURTAIN 4 Down CURTAIN 3 Down 1 2 3 C A R C A R C A R C A R CURTAIN 2 Down CURTAIN 1 Down http://www.lintronic.dk...
- Page 6 LINTRONIC RELAY 208 Relays (controlling motors) Suggested mode: 1-32, Up/Down Motors powered by 12 - 48 volt dc 1 2 3 C A R C A R C A R C A R 12 - 48 volt dc MOTOR Down...
- Page 7 LINTRONIC RELAY 208 SOMFY REMOTE CONTROLLED CURTAINS If curtains are already installed … see next page. If curtains are not already installed, then save the RF receiver and the remote control and control curtains motors directly as normal 12 or 24 volts motors.
- Page 8 LINTRONIC RELAY 208 SOMFY REMOTE CONTROLLED CURTAINS If you want both SOMFY control as well as B&O control and/or computer control, use the below wiring. C A R C A R Plus Minus MOTOR POWER RF RECEIVER 230 vac 12 or 24 volt...
- Page 9 LINTRONIC RELAY 208 RF CONTROLLED CURTAINS Open the RF remote and connect/solder the relays directly to the buttons. This solution will work on any kind of RF remote control 1 2 3 C A R C A R C A R C A R http://www.lintronic.dk...
- Page 10 LINTRONIC RELAY 208 RF CONTROLLED FIREPLACE Open the RF remote and connect/solder the relays directly to the buttons. This solution will work on any kind of RF remote control 1 2 3 C A R C A R C A R...
- Page 11 LINTRONIC RELAY 208 Relays (controlling motors) Suggested mode: 1-32, Up/Down Controlling 115 - 230 vac 1 2 3 C A R C A R C A R C A R 115 - 230 vac (fused) MOTOR Down http://www.lintronic.dk...
- Page 12 LINTRONIC RELAY 208 Relays (controlling all type of lamps) Suggested mode: 1-64, On/Off Controlling 115 - 230 vac 1 2 3 C A R C A R C A R C A R 115 - 230 vac (fused) http://www.lintronic.dk...
Need help?
Do you have a question about the RELAY 208 and is the answer not in the manual?
Questions and answers