bauhaus 600 Series Installation Instructions

600 Double Drawer Basin Unit
& Basin
GL0001SCW
GL6000
x2
x4
Tools & equipment needed: Drill, 8mm Suitable drill bit, Phillips screwdriver, Spirit level, Ruler/tape measure, Pencil,
Silicone sealant (clear).
IMPORTANT - Advice and safety - Please read before installation
Please read these instructions carefully before starting installation
and keep in a safe place for future reference. ENSURE the room is
well heated and ventilated.
Check the contents of the pack carefully before installation. Bauhaus will
not be held responsible for any de-fit / re-fit costs where faulty product
has been fitted.
If any fault is found with materials or workmanship, it must be reported
immediately to the manufacturer. Remedial action will be taken, based
on information received, on condition that: 1. Full details are supplied
to the manufacturer; 2. The product has not been modified or tampered
with; 3. The manufacturer is informed of any damage/shortages prior to
installation. 4. The product has not been installed, or attempts have been
made to install.
We do not accept responsibility for any problems that may occur through
incorrect installation.
Advice & Safety
This product should be only be installed by a suitably qualified Plumber/
installer. Should the installation be completed by a non-qualified person
any product guarantee maybe considered invalid. For a claim made under
our warranty written certification of your installers qualifications can be
required.
It is advised that all doors and drawers are removed prior to fitting to avoid
unnecessary damage occurring.
It is recommended that the furniture and accessories are installed after
tiling, ensuring that the product is installed flat to the tile face and allows
product to be easily removed if required in the future.
These hints have been prepared for your guidance, you must exercise
due care at all times.
Please note that some units are heavy. Always take care when lifting, and
INSTALLATION INSTRUCTIONS
BATHROOM FURNITURE RANGE
800 Double Drawer Basin Unit
& Basin
GL0002SCW
GL8000
1000 Double Drawer Basin Unit
& Basin
GL0003SCW
x2
x4
follow health and safety guidelines. It is recommended that 2 people carry
out the installation of larger basin/vanity units.
Warning! Please check for any hidden pipes or electrical cables before
drilling holes in the floor or walls.
When using power tools always follow the manufacturer's user
instructions.
Always use the correct wall fixings for non-solid walls – not supplied.
Important pre-installation notes
The carcass on coloured products is supplied with a protective film. This
should be removed only after installation is complete. Simply peel off and
wipe down with a well wrung chamois leather or micro fibre cloth.
To ensure full working use of the drawers we recommend the use of
Bauhaus basin furniture trap BTR0410W.
Care & Cleaning
Ceramic products should be cleaned regularly with warm soapy water,
then rinsed with clean water and, if desired, dried and polished with a soft
cloth. Limescale deposits can be removed using a 50:50 solution of warm
water and limescale remover and soft clean cloth.
We advise against the practice of leaving strong cleaners or bleach in
ceramic products overnight this will permanently damage the glazed
surface.
Use a well wrung chamois leather or micro fibre cloth to clean furniture
carcasses.
If any maintenance is required then it must be carried out by a qualified
Plumber.
The manufacturer reserves the right to make technical modifications
without prior notice.
GLIDE
Tower Storage Unit
Including 1 pre-fitted shelf and
2 adjustable shelves
GL1000
x2
x4
GL3590F
x2
x4