POSITION A DATE-SETTING If your YEMA watch is equipped with a date, pull the crown to POSITION A. Then simply turn it clockwise until the desired date appears in the window. IMPORTANT: Do not make date adjustments when the time on the watch reads between the hours of 9:00pm and 3:00am.
POSITION B TIME SETTING In order to adjust the time, pull out the crown to the last notch. Then turn it in either direction until the hands indicate the correct time. If the crown is pulled to POSITION B while the chronograph is started, the chronograph hands will continue to move.
Page 7
PUSHER A START/STOP CHRONOGRAPH Press PUSHER A to start the chronograph. The chronograph hands will start moving. Press PUSHER A again to stop the chronograph. The chronograph hands stop to indicate the elapsed time. The center 1/5 chronograph second hand displays the elapsed seconds while the 6 O’clock sub-register shows the elapsed minutes (maximum 60 minutes) PUSHER B...
Page 9
Pull crown to POSITION 2 then press PUSHER A for 2 seconds. The minute chronograph hand turns a full round and can now be set to correct “0” position. Press PUSHER B repeatedly to set it to the “0” position. PUSHER A Then press for 2 seconds.
Page 11
The bezel on your watch has a tachymeter function used to measure a speed or a flow rate using the chronograph function. Select the desired unit of measurement (metre, kilometre, mile, litre, etc.], activate the chronograph and stop it when the desired unit is reached.
Page 13
YEMA: • Ensure that the crown is perfectly screwed down after winding up the movement and/or setting the time and the date. Once the crown is fully screwed down against the case, your YEMA watch is guaranteed waterproof.
Need help?
Do you have a question about the SPACEGRAF ZERO-G and is the answer not in the manual?
Questions and answers