Cadillac XT4 2020 Owner's Manual page 44

Cadillac XT4 Owner Manual (GMNA-Localizing-MidEast-13527545) - 2020 -
CRC - 9/16/19
44 SEATS AND RESTRAINTS
Position, and then Seat Entry
Memory. Select On or Off. See
Seat Entry Memory later in this
section.
To begin Seat Exit Memory
movement when the vehicle is
turned off and the driver door is
opened, or when the vehicle is
turned off with the driver door
already opened, select the Settings
menu, then Vehicle, then Seating
Position, and then Seat Exit
Memory. Select On or Off. See
Seat Exit Memory later in this
section.
See Vehicle Personalization 0 129
for additional setting information.
Identifying Driver Number
To identify the driver number:
1. Move your RKE transmitter away
from the vehicle.
2. Start the vehicle with another
key or RKE transmitter. The DIC
should display the driver number
for the other RKE transmitter.
Turn the vehicle off and remove
the key or RKE transmitter from
the vehicle.
3. Start the vehicle with the initial
key or RKE transmitter. The DIC
should display the driver number
of your RKE transmitter.
Saving Memory Positions
Read these instructions completely
before saving memory positions.
To save preferred driving positions
1 and 2:
1. Turn the vehicle on or to ACC/
ACCESSORY.
A DIC welcome message may
indicate driver number 1 or 2.
2. Adjust all available memory
features to the desired driving
position.
3. Press and release SET; a beep
will sound.
4. Immediately press and hold the
1 or 2 memory button matching
the above DIC welcome message
until two beeps sound.
If too much time passes between
releasing SET and pressing 1, the
memory position will not be
saved and two beeps will not
sound. Repeat Steps 3 and 4.
1 or 2 corresponds to the driver
number. See Identifying Driver
Number previously in this
section.
5. Repeat Steps 1 4 for a second
driver using 1 or 2.
To save the position for and Seat
Exit Memory features, repeat
Steps 1 4 using . This saves the
position for getting out of the vehicle.
Save preferred memory feature
positions to both 1 and 2 if you are
the only driver.
Manually Recalling Memory
Positions
Press and hold 1, 2, or to recall
the previously saved memory
positions if you are driver 1 or 2
identified in the DIC welcome
message.