Advertisement
Lift the safety interlock
switch off its posts.
Remove the 3 screws
securing the gearbox/
motor assembly to the
chassis.
Unplug the motor and
lift the gearbox/motor
assembly from the
chassis.
*If the motor wires are
hard-wired to the circuit
board, mark which
color wire goes to each
terminal to prevent
the burr from spinning
the wrong way after
reassembly. It should
spin clockwise.
www.baratza.com
Pg. 2
*These screws may be
Phillips, or Torx size 10*
support@baratza.com
Unplug this
rev. 4/16/2019
Advertisement
