Related Manuals for Cooke & Lewis BFU60CL
Summary of Contents for Cooke & Lewis BFU60CL
- Page 1 Built under larder fridge GB IE Built under larder fridge - Barcode: 5052931258499 WARNING: Read the instructions before using the appliance. BFU60CL-C&L-A5-GB-IM-11.indd 1 10/15/13 4:13 PM...
- Page 2 [05] x 1 [06] x 2 1 : 1 [07] x 27 (3 x 12mm) (2 for spare use) [08] x 4 (4 x 18mm) [09] x 2 (5 x 16mm) BFU60CL Built under freezer BFU60CL-C&L-A5-GB-IM-11.indd 2 10/15/13 4:13 PM...
-
Page 3: Table Of Contents
Getting started… Your product Before you start Safety more detail… Operation Care and maintenance Troubleshooting Recycling and disposal Technical and legal information Guarantee CE Declaration of conformity Appendix... Installation BFU60CL-C&L-A5-GB-IM-11.indd 3 10/15/13 4:13 PM... -
Page 4: Getting Started
Your product BFU60CL Built under larder fridge Your product 01. Thermostat dial and light 02. Removable glass shelves 03. Crisper 04. Ventilation grills 05. Leveling feet 06. Egg trays 07. Bottle shelf 08. Dairy shelf [08] [01] [02] [03] [04]... - Page 5 Your product BFU60CL Built under larder fridge Your product Shelves • The shelves may be placed in any of the guide slots within the interior of the appliance. • To remove a shelf, take off all of the items that are stored on the shelf that you want to remove.
-
Page 6: Before You Start
Before you start BFU60CL Built under larder fridge Things to check before you start To avoid the risks that are always present when you use an electrical appliance it is important that this appliance is installed correctly and that you read the safety instructions carefully to avoid misuse and hazards. -
Page 7: Safety
Safety BFU60CL Built under larder fridge These instructions are for your safety. Please read through them thoroughly prior to installation and retain them for future reference. • All installation work must be carried out by a competent person or qualified electrician. • This appliance must be installed correctly by a suitably qualified person, strictly following the manufacturer’s instructions. - Page 8 Safety BFU60CL Built under larder fridge • During the transportation and installation of the appliance, make sure that the refrigeration pipework does not get damaged. • If it does become damaged then sources of ignition and open flames should be avoided. Also the room that the appliance is situated in should be thoroughly ventilated.
- Page 9 Safety BFU60CL Built under larder fridge Do not attempt to use your appliance outdoors or any place where it is likely to come into contact with the elements. Before cleaning the appliance or performing maintenance work, ensure that the appliance has been disconnected from your mains supply.
-
Page 10: In More Detail
Operation BFU60CL Built under larder fridge Product functions Before switching on • Make sure that it has been installed by a suitably qualified person, as per the information contained in installation instructions. • After delivery, wait for eight hours before connecting the appliance to your mains supply. This will allow any refrigerant gasses that may have been disturbed during the transportation process to settle. •... - Page 11 Operation BFU60CL Built under larder fridge Product functions • The thermostat automatically regulates the temperature inside the refrigerator, depending on what number you have turned the thermostat control knob to: Position <0> means that the appliance will not operate. Position <1> provides highest temperature inside of the fridge.
- Page 12 Operation BFU60CL Built under larder fridge Arranging and storing food in your refrigerator • Some organic solutions, such as the oils in lemon/orange peel and acid in butter, can cause damage to the plastic parts contained inside of the refrigerator. • Do not open the refrigerator door too often or leave the door open for long periods of time, as this will increase the temperature inside of the appliance.
-
Page 13: Care And Maintenance
Operation BFU60CL Built under larder fridge Care and maintenance Saving energy when using your refrigerator Disposal • If you're going to throw out your old refrigerator, see if there's a chlorofluorocarbons (CFCs) recycler in your area. The government department which looks after the environment in your area may be able to help you. -
Page 14: Troubleshooting
Care and maintenance BFU60CL Built under larder fridge Troubleshooting Replacing the light bulb Warning: Please ensure that your appliance is disconnected from your mains supply before attempting to replace the light bulb. • Press the rear end of the bulb cover until the sides release and then lift the bulb cover clear of the bulb. -
Page 15: Recycling And Disposal
Troubleshooting/Recycling and disposal BFU60CL Built under larder fridge Technical and legal information Troubleshooting Please refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance. Recycling and disposal Environmental protection Waste electrical products should not be disposed of with household waste. -
Page 16: Guarantee
Guarantee BFU60CL Built under larder fridge Guarantee This appliance is covered by a full manufacturer’s 24 month parts and labour guarantee and covers all parts and labour costs associated with the repair of the appliance in a domestic environment. We will repair any defect that arises due to faulty materials or workmanship and use genuine manufacturers parts. - Page 17 Guarantee BFU60CL Built under larder fridge Guarantee Exclusions to the guarantee (continued) Claims arising from non-domestic use or commercial environment. Any gas appliance not fitted by a gas safe qualified installer. If no fault is found then GAA reserves the right to charge for the call out at the going rate of £55.00 plus VAT. In the course of the service work carried out it may be necessary to remove the built in appliance from its fitted position. If the appliance is glued, grouted or tiled in such...
-
Page 18: Ce Declaration Of Conformity
CE Declaration of Conformity BFU60CL Built under larder fridge CE Declaration of Conformity MANUFACTURER: CATA ADDRESS: C/ Ter nº 2, Torelló 08570 - Barcelona (Spain) We hereby certify that the mentioned accessory complies with the essential require- ments of the European Directives applicable, including their modifications and the... -
Page 19: Installation
In order to find out the climatic rating of your appliance, you should check the rating plate. The rating plate is located on the front left edge of the inside of the fridge. You will need to open the door of your appliance to be able to find it. The rating plate will indicate the ambient temperature range that your appliance will function correctly within. BFU60CL-C&L-A5-GB-IM-11.indd 19 10/15/13 4:13 PM... - Page 20 When the connection is completed, no stray strands or cut wire should be present. The cord clamp must be secured over the outer sheath. • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. BFU60CL-C&L-A5-GB-IM-11.indd 20 10/15/13 4:13 PM...
- Page 21 Reversing the door • This procedure MUST be completed before the furniture door is attached. • Any parts that you remove from the appliance whilst reversing the door, should be retained for later use. Warning: Take care when opening the hinges, they are sprung loaded and there is the risk of injury if they close on your hand. BFU60CL-C&L-A5-GB-IM-11.indd 21 10/15/13 4:13 PM...
- Page 22 Reattach the appliance door and then fully re-tighten the retaining screws (1) and the door retaining screws (2). Insert the cover caps (3) into the holes that are now exposed on the right hand side of the cabinet. BFU60CL-C&L-A5-GB-IM-11.indd 22 10/15/13 4:13 PM...
- Page 23 Remove the grill on the base of the appliance by unscrewing the screws on each side of the grill and then pull the grill towards you. BFU60CL-C&L-A5-GB-IM-11.indd 23 10/15/13 4:13 PM...
- Page 24 If the appliance is not level, then the door and door seal may be affected. • A cut out must be made in the plinth/kickboard for ventilation. The cut out should measure 600mm in width and 90-140mm in height. • Insert the plinth/kickboard and then refit the grill in its original position to hold it in place. Note Please note that as shown in the above drawing, an appropriately sized ventilation cut MUST be made in the furniture plinth/kickboard. BFU60CL-C&L-A5-GB-IM-11.indd 24 10/15/13 4:13 PM...
- Page 25 If you need the appliance door to open from the other side, then please reverse the door before commencing the installation process. (See Reversing the door section). Undo the hexagonal screws from the two adjusting bolts that are located on the top of the appliance door and then remove the mounting bracket. BFU60CL-C&L-A5-GB-IM-11.indd 25 10/15/13 4:13 PM...
- Page 26 This will allow you a 5mm gap from the top of the furniture door, to the underneath of your worktop. • Fix the mounting bracket to the furniture door using the screws provided and a cross-head screwdriver. These screws should be fully tightened. BFU60CL-C&L-A5-GB-IM-11.indd 26 10/15/13 4:13 PM...
- Page 27 [07] x 4 (3 x 12mm) [07] [09] [09] x 2 (5 x 16mm) [07] [09] Fix the two brackets [04] to the bottom of the furniture door and the underneath of the appliance door using screws [07] and [09]. BFU60CL-C&L-A5-GB-IM-11.indd 27 10/15/13 4:13 PM...
- Page 28 It is possible to make minor adjustments to the position of the furniture door using the screws on the top and the bottom of the appliance door. You should make these adjustments so that the furniture door is level. BFU60CL-C&L-A5-GB-IM-11.indd 28 10/15/13 4:13 PM...
- Page 29 Open the appliance door. h) Use a suitably sized drill bit to drill through the three holes in the bracket, into the work top. Note The drill bit should be appropriate for the material that your work top is made from. Secure the bracket to the underside of the worktop, using the screws [7] provided. Note These screws should be fully tightened. BFU60CL-C&L-A5-GB-IM-11.indd 29 10/15/13 4:13 PM...
- Page 30 [07] [09] Rectangular iron plates [06] are spare parts, for better fitting between the appliance and the wooden door. Check that the door opens and shuts without snagging, as well as checking that the door is sealing correctly. The appliance is now ready to be switched on. BFU60CL-C&L-A5-GB-IM-11.indd 30 10/15/13 4:13 PM...
- Page 31 BFU60CL-C&L-A5-GB-IM-11.indd 31 10/15/13 4:13 PM...
- Page 32 B&Q plc, Chandlers Ford, Hants, SO53 3LE United Kingdom www.diy.com BFU60CL-C&L-A5-GB-IM-11.indd 32 10/15/13 4:13 PM...