Jitron JTMI-603M Quick Manual

NON CONTACT FOREHEAD THERMOMETER
Thank you for choosing Jitron Non Contact Forehead Thermometer JTMI-603M. The thermometer does not
radiate any infrared rays and is designed for non contact forehead temperature measurement. This Quick Guide
provides important steps that help you to test your temperature. Please read the detailed User's Guide in the box
carefully before using the meter.
Before you begin, make sure that the sensor is clean and without damage. Patients and thermometer should
stay in steady state room condition for at least 30 minutes before the measurement. We recommend you
measure 3 times and take the average reading as your temperature.
In power on mode, press the "MODE" button to switch between the modes HUMAN, OBJECT and both in silent
modes. Set at Human mode for forehead temperature measurement.
QUICK GUIDE

FOREHEAD MEASUREMENT

1. Forehead measurement is convenient. It requires a
clean forehead to scan. Clean the forehead before the
measurement.
2. Press the "SCAN" button to switch ON the meter. Aim
the sensor at the forehead 0.5 to 3 cm away. Then press
and hold the "SCAN" button until you hear a beep sound.
The measurement will be displayed in one second.
3.
4. Wait 20 seconds for the next measurement.
5. As the forehead temperature is likely to be affected by
many factors including sweat, oil, cosmetics and
surroundings the forehead reading can be taken as a
reference only.

MODE SELECTION

JTMI-603M