Table of Contents
Advertisement
10 Hookups with a Stereo TV
VR623CAT
VIDEO (yellow) and
AUDIO (red and white) OUT Jacks
VR423CAT
VIDEO (yellow) and
AUDIO (white) OUT Jacks
Audio and Video cables are not supplied.
1
Connect the antenna or cable to the ANT(enna) IN Jack on the back of the VCR.
2
Connect a video cable to the yellow VIDEO OUT Jack on the back of the VCR. Then, connect
the other end of the video cable to the VIDEO IN Jack on your TV.
3
If you have the VR623CAT, connect a stereo audio cable to the red and white AUDIO OUT
Jacks on the back of the VCR. Then, connect the other end of the audio cable to the AUDIO
IN Jacks on your TV.
If you have the VR423CAT, connect an audio cable to the white AUDIO OUT Jack on the back
of the VCR. Then, connect the other end of the audio cable to the AUDIO IN Jack on your TV. If
your TV has Right and Left AUDIO IN Jacks, you must use a "Y" splitter audio cable as illustrated to deliver
audio to the TV's right and left channels. This hookup will not give you stereo sound. To get stereo sound, use
the connections on pages six - seven and select the channel to be viewed at the TV (with the VCR turned off).
4
Turn on your TV, making sure it is in Line Input mode. This might be referred to as the TV's Audio/Video In
channel or the Auxiliary In channel. Please refer to your TV owner's manual for details.
1
antenna or cable to
ANT(enna) IN Jack
AUDIO
ANT
IN
L
OUT
IN
R
VIDEO
OUT
CH3 CH4
OUT
IN
2
Video Cable
OR
1
antenna or cable to
ANT(enna) IN Jack
ANT
IN
AUDIO
OUT
IN
OUT
CH3 CH4
VIDEO
2
Video Cable
Audio and Video IN
Jacks on TV
3
Stereo Audio Cable
Audio and Video
IN Jacks on TV
3
"Y" splitter
Audio Cable
Advertisement
Table of Contents
