Table of Contents
Advertisement
Hookups with a Cable Box/Direct Broadcast System (cont'd) 9
With this connection:
You may watch one channel while recording another.
You may not record scrambled channels.
1
VCR
AUDIO
ANT
IN
L
OUT
IN
R
VIDEO
OUT
CH3 CH4
OUT
IN
Cable
Signal
Connections
1
Connect a Cable signal to the VCR's ANT(enna) IN Jack.
2
Use the supplied black RF coaxial cable to connect the OUT Jack on
the VCR to the IN Jack on the Cable Box/DBS.
3
Use a second RF coaxial cable (not supplied) to connect the OUT
Jack on the Cable Box/DBS to the ANTENNA IN Jack on the TV.
Recording One Channel/Watching Another
1
Put the Cable Box/DBS on the same channel as the VCR's
CH3/CH4 switch. Set the TV to the Cable Box/DBS output channel
(03 or 04). Then, with the VCR in VCR position (the VCR light will
appear on the display panel), use the CH(annel) o/p buttons to
select the channel you want to record at the VCR. Start
the recording.
2
Press the VCR/TV button once to put the VCR in TV posi-
tion. (The VCR light will disappear.)
3
Select the channel you want to watch at the Cable
Box/DBS.
4
To return to the channel you are recording, set the Cable Box/DBS
to the same channel as the VCR's CH3/CH4 switch. Press the
VCR/TV button so that the VCR is in VCR position again. The VCR
light will appear on the display panel. The channel you are recording
will appear on the TV screen. Press the STOP/p button to stop
recording.
2
Cable Box/DBS
IN
O UT
RF coaxial cable
3
RF coaxial cable
Helpful Hint
• When you play a tape, make sure
the Cable Box/DBS is set to the
same channel as the CH3/CH4
switch on the VCR. Set the TV to
the Cable Box/DBS output channel
(03 or 04).
7 5
A N T
/
C A B
L E
TV's ANTENNA
IN Jack
Advertisement
Table of Contents
